Ad
related to: sprinklers not enough pressure to pump 2 gpm water to make 20 mg of alcohol
Search results
Results From The WOW.Com Content Network
Using metric units, the volumetric flow rate of a nozzle is given by =, [1] [2] where q is the flow rate in litres per minute ( l/min ), p is the pressure at the nozzle in bar and K is the K-factor is given in units of (/) /.
A fire sprinkler system is an active fire protection method, consisting of a water supply system providing adequate pressure and flowrate to a water distribution piping system, to which fire sprinklers are connected. Although initially used only in factories and large commercial buildings, systems for homes and small buildings are now available ...
A fire pump usually refers to a pressure-increasing component of the water supply for fixed-place fire suppression systems such as fire sprinklers, standpipes, and foam systems. Fire pumps are also a critical component integrated into fire trucks and fire boats, and serve a similar purpose boosting water supplies for firefighting hose operations.
In locations where a municipal connection is not possible or practical, the required water may be drawn from an open body of water (e.g., lake, pond, river) or a water storage tank. Hydraulic calculations determine if the available water supply pressure is adequate to provide the sprinkler system design flowrate.
[13] [14] The total water extraction from center-pivot irrigation in the area is estimated to be about 5.42 million acre-feet of water per year. [15] In 1950, irrigated cropland covered 100,000 hectares (250,000 acres). With the use of center-pivot irrigation, nearly 1.2 million hectares (3 million acres) of land were irrigated in Kansas alone.
For premium support please call: 800-290-4726 more ways to reach us
The majority of automatic fire sprinklers operate individually in a fire. Contrary to motion picture representation, the entire sprinkler system does not activate at the same time, unless the system is a special deluge type. [19] [20] Open orifice sprinklers are only used in water spray systems or deluge sprinklers systems.
The water inside a charged hose line causes it to be very heavy, and high-water pressure causes it to be stiff and unable to make a tight turn while pressurized. When a fire hydrant is unobstructed, this is not a problem, as there is enough room to adequately position the hose. [clarification needed]