Ads
related to: craftsman metric 3/8 12 point socket set
Search results
Results From The WOW.Com Content Network
Pass-through sockets and ratchets are built for 1 ⁄ 4-inch, 3 ⁄ 8-inch and 1 ⁄ 2-inch sets in both SAE and metric sizes. By using a fine tooth ratchet and socket system that allow a pass-through ratchet to be used as a conventional ratchet handle with interchangeable 1 ⁄ 4-inch and 3 ⁄ 8-inch drives some ratchets can be used with ...
where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8-16 tap, the above formula would produce 5 ⁄ 16, which is the correct tap drill diameter. The above formula ultimately results in an approximate 75% ...
From top: Spade, brad point, masonry, and twist drills bits Drill bit (upper left), mounted on a pistol-grip electric drill A set of masonry drills. A drill bit is a cutting tool used in a drill to remove material to create holes, almost always of circular cross-section. Drill bits come in many sizes and shapes and can create different kinds of ...
The Craftsman trademark was registered by Sears on May 20, 1927. [2] Arthur Barrows, head of the company's hardware department, liked the name Craftsman and reportedly bought the rights to use it from the Marion-Craftsman Tool Company for $500 (equivalent to $8,770 in 2023). [3] The brand's early customers were mostly farmers.
Easco continued the Craftsman contract with Sears. By 1969, the parent company was known as Easco Corporation. [1] Tools made by MDF for Sears have a "V" maker's mark on them, those by Danaher had a "V^" (V and upside down V, sometimes a right-side up V). Variations of the "VV" exist including three digit codes on tools such as ratchets.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...