Search results
Results From The WOW.Com Content Network
A wildcard mask can be thought of as an inverted subnet mask. For example, a subnet mask of 255.255.255.0 (11111111.11111111.11111111.00000000 2) inverts to a wildcard mask of 0.0.0.255 (00000000.00000000.00000000.11111111 2). A wild card mask is a matching rule. [2] The rule for a wildcard mask is: 0 means that the equivalent bit must match; 1 ...
mask Netmask: The netmask (subnet mask) associated with the network destination; Gateway: The forwarding or next hop IP address over which the set of addresses defined by the network destination and subnet mask are reachable; metric Metric: Integer cost metric (ranging from 1 to 9999) for the route
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
Since the introduction of CIDR, however, the assignment of an IP address to a network interface requires two parameters, the address and a subnet mask. Given an IPv4 source address, its associated subnet mask, and the destination address, a router can determine whether the destination is on a locally connected network or a remote network.
The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.
RFC 1918 name IP address range Number of addresses Largest CIDR block (subnet mask) Host ID size Mask bits Classful description [Note 1]; 24-bit block: 10.0.0.0 – 10.255.255.255: 16 777 216
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
In case of overlapping or equal routes, algorithms consider the following elements in priority order to decide which routes to install into the routing table: Prefix length: A matching route table entry with a longer subnet mask is always preferred as it specifies the destination more exactly.