Ads
related to: on off magnetic welding clamps holder set of 4 speed and 5amazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
A switchable magnetic device usually consists of a magnetic circuit with permanent magnets. By moving some parts of this circuit, the magnetic flux can be directed within the device (off position) or externally (on position). [3] One type of magnetic switchable device is made from two blocks of iron, with a round cavity bored through the center.
Magnetic pulse welding (MPW) is a solid state welding process that uses magnetic forces to weld two workpieces together. The welding mechanism is most similar to that of explosion welding . [ 1 ] Magnetic pulse welding started [ clarification needed ] in the early 1970s, when the automotive industry began to use solid state welding.
A robust robotic arc welding fixture is a part-holding tool used to constrain components for welding in an automated system. [15] Welding fixtures locate parts using these clamps to secure important aspects of the subcomponent, such as holes, slots, or datum surfaces. Careful considerations must be made when designing welding fixtures.
Gripe (a specialized clamp, tightened with a wedge, for holding strakes in position when building a clinker boat) Hand clamp [1] Handscrew (upper right in the top photo) Holdfast, a bench clamp for holding things to a bench top or side The bench forms the fixed jaw. Magnetic clamp (see Magnetic base) Mitre clamp; Pipe clamp (top of the top photo)
The actual welding technique utilized depends on the electrode, the composition of the workpiece, and the position of the joint being welded. The choice of electrode and welding position also determine the welding speed. Flat welds require the least operator skill, and can be done with electrodes that melt quickly but solidify slowly.
Magnetic arc blow is known to begin at field densities as low as 10 gauss and becomes severe at densities of, equal to or greater than, 40 gauss; it is directional and can be classified as forward or backward moving along the joint, but can occasionally occur to the sides depending on the orientation of the poles to the workpiece.