Search results
Results From The WOW.Com Content Network
A Yosemite bowline is made from a bowline with the free end wrapped around one leg of the loop and tucked back through the knot, a final round turn and reeve commonly known as a "Yosemite finish." The knot's security is enhanced by preventing the bowline capsizing to form a highly dangerous slip knot .
As mentioned earlier, this knot can replace the figure-eight knot when tying into a climbing harness by tying a regular bowline knot and then re-threading it, such as is done with a figure eight knot. However, it is critical to use a strong backup knot with plenty of tail beyond the knot, as the knot may untie during long climbs. The advantage ...
A Tensionless hitch is an anchor knot used for rappelling or rope rescue. Unlike most knots, the tensionless hitch retains a 100% efficiency rating, [ 3 ] meaning the strength of the knot is equal to the strength of the rope; it is not a significant stress riser .
Karash double loop is a common name for a knot forming two loops. This knot has been a known variant of the Bowline on a bight per the International Guild of Knot Tyers, referred to as bowline twist or twisted collar bowline on a bight. The knot is also referred to as nœud de fusion in French references and sometimes called Fusion knot in English.
The knot is tied in the same way the original bowline is, except with a doubled rope (using a bight). An overhand loop is formed in the rope, the working end is passed back through that loop, behind the standing part of the rope, back through the loop and pulled tight.
How to tie a barrel hitch. The barrel hitch is made by tying an overhand knot, leaving plenty of free rope at the working end. Where the rope crosses itself in the middle of the knot (near the target), grab the strand of rope on top and bring it towards you, then lay it back down. The result should resemble stage 2: note where the target is.
The security of the knot arises from the fact that at step 3 in the tying sequence the knot is a Double Harness Bend (ABoK #1420). The additional step of passing the ends through the outer loops to complete the knot results in each line entering and exiting the knot being clamped at two points within the knot.
An autoblock (or autobloc or "third hand") is a rope device used in climbing and caving for both rappelling (downward) and ascending (upward). [1] [2]While rappelling, it slides freely down the rope when pushed downward by the hand, allowing a controlled descent, but jams in the event of a sudden drop or loss of control, stopping the descent.