When.com Web Search

  1. Ads

    related to: perforated gypsum plaster board repair

Search results

  1. Results From The WOW.Com Content Network
  2. Drywall - Wikipedia

    en.wikipedia.org/wiki/Drywall

    Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...

  3. Spackling paste - Wikipedia

    en.wikipedia.org/wiki/Spackling_paste

    Spackling paste is comparable and contrastable with joint compound as both look similar and serve the similar purpose of filling in low spots in walls and ceilings. [3] The chief differences are that spackling paste typically dries faster, shrinks less during drying, and is meant for smaller repairs, and not for a whole room or house.

  4. Gypsum block - Wikipedia

    en.wikipedia.org/wiki/Gypsum_block

    A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.

  5. Plasterwork - Wikipedia

    en.wikipedia.org/wiki/Plasterwork

    In the 14th century, decorative plasterwork called pargeting was being used in South-East England to decorate the exterior of timber-framed buildings. This is a form of incised, moulded or modelled ornament, executed in lime putty or mixtures of lime and gypsum plaster.

  6. Lath and plaster - Wikipedia

    en.wikipedia.org/wiki/Lath_and_plaster

    In use as early as 1900, rock lath (also known as "button board," "plaster board" or "gypsum-board lath"), is a type of gypsum wall board (essentially an early form of drywall) with holes spaced regularly to provide a 'key' for wet plaster. [3] Rock lath was typically produced in sheets sized 2 by 4 feet (610 by 1,220 mm).

  7. Lath - Wikipedia

    en.wikipedia.org/wiki/Lath

    The finish side (to which plaster is trawled) is treated with gypsum crystals for the plaster to chemically bond to and is sometimes perforated to allow mechanical bonding. [ citation needed ] It is commonly used in place of wood lath since it is noncombustible, easy to use, and can give better results.