Search results
Results From The WOW.Com Content Network
DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required. Up to a signal voltage of 2.5 Volts (which may vary with different fan/motor manufacturers) the fan will be in a stopped ...
Whole house fans were the only method for cooling homes in the early 1900s. Air conditioning was invented by Carrier in 1907 but did not become popular until the 1950s. Whole house fans are still ideal for cooling homes when the air outside is cooler than the air inside. [citation needed]
An attic fan installed underneath a roof. A powered attic ventilator, or attic fan, is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used. An attic fan can be gable mounted or roof mounted. Additional ...
The D-gun atomises the powder feedstock into extremely small particles (80–95% of particles by total number are of size <100 nm). This means proper extraction facilities are required for inhalation safety purposes. Also isolation of the D-gun is recommended to avoid operators breathing in the dangerous dust and fumes. [14]
Portable fan heater A Japanese kerosene fan heater that burns kerosene for fuel. It contains an electric fan and computer controls. Electric fan heater. A fan heater, also called a blow heater, is a heater that works by using a fan to pass air over a heat source (e.g. a heating element). [1]
Officials say the state is better equipped to weather such extreme heat this year, but late summer could still be a test. California has new weapons to battle summer blackouts: Battery storage ...
The ASHRAE Handbook is the four-volume flagship publication of the nonprofit technical organization ASHRAE (American Society of Heating, Refrigerating and Air-Conditioning Engineers [a]).
Supply diffusers in the ceiling are fed by fan coil units in the ceiling void or by air handling units in a remote plant room. The fan coil or handling unit takes in return air from the ceiling void and mix this with fresh air and cool, or heat it, as required to achieve the room design conditions. This arrangement is known as 'conventional ...