Search results
Results From The WOW.Com Content Network
This article gives a list of conversion factors for several ... ≡ 0.3048 m ≡ 1 ⁄ 3 yd ≡ 12 inches ≡ 0.3048 m ... Currently defined in US as 3 Statute miles ...
ftin (feet/inches) ft m (foot m) hand: hand h 1.0 h (4 in; 10 cm) inch: in in Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 in (25 mm) in cm; in mm; Maritime units: nautical mile: nmi nmi the international standard nautical mile 1.0 nmi (1.9 km; 1.2 mi) nautical mile: oldUKnmi (admiralty nmi) nmi 6080 ft the pre-1970 ...
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
A ruler, depicting two customary units of length, the centimeter and the inch. A unit of length refers to any arbitrarily chosen and accepted reference standard for measurement of length. The most common units in modern use are the metric units, used in every country globally. In the United States the U.S. customary units are also in use.
Historically, a wide range of units was used for the same type of quantity. In different contexts length was measured in inches, feet, yards, fathoms, rods, chains, furlongs, miles, nautical miles, stadia, leagues, with conversion factors that were not based on power of ten.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
The "old English mile" of the medieval and early modern periods varied but seems to have measured about 1.3 international miles (2.1 km). [17] [18] The old English mile varied over time and location within England. [18] The old English mile has also been defined as 79,200 or 79,320 inches (1.25 or 1.2519 statute miles). [19]
This was an official unit of measurement in South Africa until the 1970s, and was defined in November 2007 by the South African Law Society as having a conversion factor of 1 morgen = 0.856 532 hectares. [28] This unit of measure was also used in the Dutch colonial province of New Netherland (later New York and parts of New England). [29] [30]