Search results
Results From The WOW.Com Content Network
The DNP3 protocol is compliant with IEC 62351-5. Some vendors support encryption via bump-in-the-wire for serial communications or virtual private networks for Internet Protocol-based communications. One of the most popular bump-in-the-wire methods began originally as AGA-12 (American Gas Association) in 2003, later becoming IEEE Std. 1711-2010 ...
WITS-DNP3 is a DNP3 protocol based protocol primarily used for larger 'always-on' utility assets. WITS-DNP3 is very well suited to traditional SCADA Telemetry control operations. WITS-DNP3 is based on the DNP3 protocol level2+, and uses DNP3’s generic protocol extension mechanism to define and provide the additional functionality required by ...
IEC 61850 is an international standard defining communication protocols for intelligent electronic devices at electrical substations.It is a part of the International Electrotechnical Commission's (IEC) Technical Committee 57 reference architecture for electric power systems. [1]
The Inter-Control Center Communications Protocol (ICCP or IEC 60870-6/TASE.2) [3] is being specified by utility organizations throughout the world to provide data exchange over wide area networks (WANs) between utility control centers, utilities, power pools, regional control centers, and Non-Utility Generators.
These communication protocols, with the exception of Modbus (Modbus has been made open by Schneider Electric), are all SCADA-vendor specific but are widely adopted and used. Standard protocols are IEC 60870-5-101 or 104, IEC 61850 and DNP3. These communication protocols are standardized and recognized by all major SCADA vendors.
By use of standardized protocols, equipment from many different suppliers can be made to interoperate. IEC standard 60870 has six parts, defining general information related to the standard, operating conditions, electrical interfaces, performance requirements, and data transmission protocols.
“Three Hours To Change Your Life” an excerpt of the book Your Best Year Yet! by Jinny S. Ditzler This document is a 35-page excerpt, including the Welcome chapter of the book and
IEC 60870-5-104 (IEC 104) protocol is an extension of IEC 101 protocol with the changes in transport, network, link, and physical layer services to suit the complete network access. The standard uses an open TCP/IP interface to network to have connectivity to the LAN ( local area network ) and routers with different facility ( ISDN , X.25 ...