Ads
related to: floating plate shelves with grooves attached to brick board and batten
Search results
Results From The WOW.Com Content Network
A floating shelf can be supported on hidden rods or bars that have been attached to studs. A thick floating shelf may be made of a hollow-core shelf glued to a cleat. [7] A floating shelf may have two or more channels open from the back towards, but without reaching, the front, into which slide fasteners attached to the wall, typically held in place by screws inserted through the bottom of the ...
The shelf angle, in turn, is attached to major elements of the building structure such as floor beams or structural columns. Shelf angles are in reality a horizontal expansion joint which allows growth of the brick below the shelf angle and to allow movement or shrinkage of the frame without putting stresses on the brick veneer.
A shelf that is attached to a wall with concealed mounting hardware (a floating shelf bracket) is called a floating shelf. [2] A shelf or case designed to hold books is a bookshelf. The length of the shelf is based upon the space limitations of its siting and the amount of weight which it will be expected to hold.
A through groove (left) and a stopped groove. In joinery, a groove is a slot or trench cut into a member which runs parallel to the grain. A groove is thus differentiated from a dado, which runs across the grain. [1] Grooves are used for a range of purposes in cabinet making and other woodworking fields.
Also known as ledges and braced, board and batten doors are an older design consisting primarily of vertical slats: Planks – Boards wider than 9" that extend the full height of the door, and are placed side by side filling the door's width. Ledges and braces – Ledges extend horizontally across the door which the boards are affixed to.
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]