When.com Web Search

  1. Ad

    related to: recessed concrete floor tie downs for sheds installed pictures of women

Search results

  1. Results From The WOW.Com Content Network
  2. Hold down (structural engineering) - Wikipedia

    en.wikipedia.org/wiki/Hold_down_(structural...

    A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...

  3. Cellular floor raceways - Wikipedia

    en.wikipedia.org/wiki/Cellular_floor_raceways

    Cellular floor raceways are electrical wiring ducts or cells made from steel floor deck that serve as structural formwork for placement of concrete floor slabs and also as wire and cable raceways within the concrete floor slab.

  4. Tieback (geotechnical) - Wikipedia

    en.wikipedia.org/wiki/Tieback_(geotechnical)

    In geotechnical engineering, a tieback is a structural element installed in soil or rock to transfer applied tensile load into the ground. Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles , sheet piles, secant and tangent walls) to provide ...

  5. Anchor plate - Wikipedia

    en.wikipedia.org/wiki/Anchor_plate

    While the current literature is very poor, some studies have been done on analysis of anchor plates and tie-rods, for example one study dealing with concrete panels, which, although a thin veneer, may also need anchor plates to help stabilize the wall. [9] The pressure that an anchor plate provides is constantly stiff.

  6. Insulating concrete form - Wikipedia

    en.wikipedia.org/wiki/Insulating_concrete_form

    The first expanded polystyrene ICF Wall forms were developed in the late 1960s with the expiration of the original patent and the advent of modern foam plastics by BASF. [citation needed] Canadian contractor Werner Gregori filed the first patent for a foam concrete form in 1966 with a block "measuring 16 inches high by 48 inches long with a tongue-and-groove interlock, metal ties, and a waffle ...

  7. Setback (architecture) - Wikipedia

    en.wikipedia.org/wiki/Setback_(architecture)

    Above that height, the buildings are required to set back behind a theoretical inclined plane, called sky exposure plane, which cannot be penetrated by the building's exterior wall. For the same reason, setbacks may also be used in lower density districts to limit the height of perimeter walls above which a building must have a pitched roof or ...

  8. Podiatrists Say These Comfy, Supportive Shoes Are the Best ...

    www.aol.com/podiatrists-comfy-supportive-shoes...

    Just note that you should size down one. What Sharkey says: “Recovery shoes like the Hoka Ora 3 are great for hard surfaces because of their construction with foam materials specially ...

  9. Concrete slab - Wikipedia

    en.wikipedia.org/wiki/Concrete_slab

    A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).