Search results
Results From The WOW.Com Content Network
Conversion of coordinates and map positions among different map projections reference to the same datum may be accomplished either through direct translation formulas from one projection to another, or by first converting from a projection to an intermediate coordinate system, such as ECEF, then converting from ECEF to projection . The formulas ...
Hence, any 15 degree quadrangle can be identified by two letters; the easting (longitude) is given first, followed by the northing (latitude). These two letters are the first two characters of a full GEOREF coordinate. Each 15-degree quadrangle is further divided into smaller quadrangles, measuring 1 degree of longitude by 1 degree of latitude.
The resolution in this case is 1 meter, so the MGRS coordinate would represent a 1-meter square, where the easting and northing are measured to its southwest corner. If a resolution of 10 meters is enough, the final digit of the easting and northing can be dropped, so that only 4 + 4 digits are used, representing a 10-meter square.
UTM eastings range from about 166 000 meters to 834 000 meters at the equator. In the northern hemisphere positions are measured northward from zero at the equator. The maximum "northing" value is about 9 300 000 meters at latitude 84 degrees North, the north end of the UTM zones. The southern hemisphere's northing at the equator is set at 10 ...
Transformation of geographic coordinates (longitude and latitude) to Cartesian (x,y) or polar (r, θ) plane coordinates. In large-scale maps, Cartesian coordinates normally have a simple relation to eastings and northings defined as a grid superimposed on the projection. In small-scale maps, eastings and northings are not meaningful, and grids ...
The set of parameters can vary based on the type of project and the conventions chosen for the projection. For the transverse Mercator projection used in UTM, the parameters associated are the latitude and longitude of the natural origin, the false northing and false easting, and an overall scale factor. [7]
WKT can describe coordinate reference systems. For example, the WKT below describes a two-dimensional geographic coordinate reference system with a latitude axis first, then a longitude axis. The coordinate system is related to Earth by the WGS84 geodetic datum:
(On the sphere it depends on both latitude and longitude.) The scale is true on the central meridian. • The projection is reasonably accurate near the equator. Scale at an angular distance of 5° (in latitude) away from the equator is less than 0.4% greater than scale at the equator, and is about 1.54% greater at an angular distance of 10°. •