Search results
Results From The WOW.Com Content Network
Switch on time: LEDs light up extremely quickly. A typical red indicator LED achieves full brightness in under a microsecond. [69] LEDs used in communications devices can have even faster response times. Focus: The solid package of the LED can be designed to focus its light. Incandescent and fluorescent sources often require an external ...
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
The introduction of LED lighting has greatly improved this by approx. 90% when compared to a halogen downlight or spotlight. LED lamps or bulbs are now available to retro fit in place of high energy consumption lamps. Uplighting is less common, often used to bounce indirect light off the ceiling and back down. It is commonly used in lighting ...
If an LED lamp does not have free air circulation, the LED is likely to overheat, resulting in reduced life or early failure. The thermal design of the system must allow for the ambient temperature surrounding the lamp; a lamp in a freezer experiences a lower ambient than a lamp in a billboard in a sunny climate.
Solid-state lighting (SSL) is a type of lighting that uses semiconductor light-emitting diodes (LEDs), organic light-emitting diodes (OLED), or polymer light-emitting diodes (PLED) as sources of illumination rather than electrical filaments, plasma (used in arc lamps such as fluorescent lamps), or gas.
Halogen lamps are sometimes used for inspection lights and microscope stage illuminators. Halogen lamps were used for early flat-screen LCD backlighting, but other types of lamps such as CCFL and now LED are used. Halogen lamps are used as the heating element in the fuser of many types of laser printers. The long tubular lamp heats the fuser ...
Luminous efficacy can be normalized by the maximum possible luminous efficacy to a dimensionless quantity called luminous efficiency.The distinction between efficacy and efficiency is not always carefully maintained in published sources, so it is not uncommon to see "efficiencies" expressed in lumens per watt, or "efficacies" expressed as a percentage.
The dental LED curing lights use LED’s that produce a narrow spectrum of blue light in the 400–500 nm range (with a peak wavelength of about 460 nm), which is the useful energy range for activating the CPQ molecule most commonly used to initiate the photo-polymerization of dental monomers."