Search results
Results From The WOW.Com Content Network
On an IBM mainframe, a power-on reset (POR) is a sequence of actions that the processor performs either due to a POR request from the operator or as part of turning on power. The operator requests a POR for configuration changes that cannot be recognized by a simple System Reset .
A battery management system (BMS) is any electronic system that manages a rechargeable battery (cell or battery pack) by facilitating the safe usage and a long life of the battery in practical scenarios while monitoring and estimating its various states (such as state of health and state of charge), [1] calculating secondary data, reporting that data, controlling its environment ...
With a BDM (1 wire interface) or JTAG (standard JTAG) debug port, you control and monitor the microcontroller solely through the stable on-chip debugging services. This debugging mode runs even when the target system crashes and enables developers to continue investigating the cause of the crash.
A battery indicator (also known as a battery gauge) is a device which gives information about a battery. This will usually be a visual indication of the battery's state of charge . It is particularly important in the case of a battery electric vehicle .
General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.
Ultium is characterized by a modular layout, using an Ultium battery to supply power to one or two Ultium Drive unit(s) using a common set of power electronics (charging, battery management system, and inverter). The high-voltage battery is composed of pouch cells that can be stacked horizontally or vertically, depending on the form factor ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
KY-57 voice encryptor. Note fill port in center. A KYK-13 fill device. A fill device or key loader is a module used to load cryptographic keys into electronic encryption machines. Fill devices are usually hand held and electronic ones are battery operated.