Ads
related to: corrosive flux in metal
Search results
Results From The WOW.Com Content Network
Rosin used as flux for soldering A flux pen used for electronics rework Multicore solder containing flux Wire freshly coated with solder, held above molten rosin flux. In metallurgy, a flux is a chemical reducing agent, flowing agent, or purifying agent. Fluxes may have more than one function at a time.
The flux powder is supplied by the hopper on the left hand side, then follow three filler wire guns and finally a vacuum cleaner. A submerged arc welder used for training Close-up view of the control panel A schematic of submerged arc welding Pieces of slag from submerged arc welding exhibiting glassy surface due to silica (SiO 2 ).
For satellites, this will also reduce weight, slightly but usefully. In high humidity, since even non-corrosive flux might remain slightly active, the flux may be removed to reduce corrosion over time. Some fluxes are corrosive and flux residue must be removed after soldering. If not properly cleaned, the flux may corrode the joint or the PCB.
Magnetic flux leakage (TFI or Transverse Field Inspection technology) is a magnetic method of nondestructive testing to detect corrosion and pitting in steel structures, for instance: pipelines and storage tanks. The basic principle is that the magnetic field "leaks" from the steel at areas where there is corrosion or missing metal.
High-temperature corrosion is a mechanism of corrosion that takes place when gas turbines, diesel engines, furnaces or other machinery come in contact with hot gas containing certain contaminants. Fuel sometimes contains vanadium compounds or sulfates, which can form low melting point compounds during combustion.
Flow-accelerated corrosion (FAC), also known as flow-assisted corrosion, is a corrosion mechanism in which a normally protective oxide layer on a metal surface dissolves in a fast flowing water. The underlying metal corrodes to re-create the oxide, and thus the metal loss continues. By definition, the rate of FAC depends on the flow velocity.
The unshaded bars indicate the location on the chart of those steels when in acidic/stagnant water ( like in the bilge ), where crevice-corrosion happens. Notice how the *same* steel has much different galvanic-series location, depending on the electrolyte it's in, making prevention of corrosion .. more difficult.
Molten salts can be highly corrosive and corrosivity increases with temperature. For the primary cooling loop, a material is needed that can withstand corrosion at high temperatures and intense radiation. Experiments show that Hastelloy-N and similar alloys are suited to these tasks at operating temperatures up to about 700 °C.