Ad
related to: telstra 4gx usb modem setupeuautomation.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Telstra was the first carrier in Australia to launch VoLTE. The service was initially available on 6 phones (Four being iPhones and two being Samsung Galaxy's). [10] Telstra have switched on the VoLTE on every one of their 4G networks across Australia but currently the 4G small cells setup in regional Australia do not have VoLTE compatibility.
An Internet-accessing smartphone may have the same capabilities as a standalone modem, and, when connected via a USB cable to a computer, can serve as a modem for the computer. Smartphones with built-in Wi-Fi also typically provide routing and wireless access point facilities. This method of connecting is commonly referred to as "tethering." [9]
While most wireless modems [220] offered by Telstra allow peak download speeds of up to 7.2 Mbit/s, a modem by Sierra Wireless was announced in 2009 that supported increased throughput. [221] The "USB 306" is marketed and sold by Telstra as the "Telstra Turbo 21 Modem", and was available in limited quantity in early 2009.
Tethering or phone-as-modem (PAM) is the sharing of a mobile device's Internet connection with other connected computers. Connection of a mobile device with other devices can be done over wireless LAN ( Wi-Fi ), over Bluetooth or by physical connection using a cable, for example through USB .
In November 2008, the International Telecommunication Union-Radio communications sector (ITU-R) specified a set of requirements for 4G standards, named the International Mobile Telecommunications Advanced (IMT-Advanced) specification, setting peak speed requirements for 4G service at 100 megabits per second (Mbit/s)(=12.5 megabytes per second) for high mobility communication (such as from ...
USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card , providing an interface for transmitting Ethernet or ATM frames onto some physical media.
Modems always start out in command mode when powered up. Here are the ways a modem can switch to data mode: After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end.
External RS-232-based (serial) modems do not have this limitation because each modem contains its own microprocessor and is unaware of other modems on the same host. USB modems may or may not have this problem, because some USB modems are simply serial modems with a "USB-to-serial" converter chipset (in which case there should be no problem ...