Search results
Results From The WOW.Com Content Network
At stall, the torque converter can produce maximum torque multiplication if sufficient input power is applied (the resulting multiplication is called the stall ratio). The stall phase actually lasts for a brief period when the load (e.g., vehicle) initially starts to move, as there will be a very large difference between pump and turbine speed.
Stall speed or minimum steady flight speed for which the aircraft is still controllable in a specific configuration. [7] [8] V S R: Reference stall speed. [7] V S R 0: Reference stall speed in landing configuration. [7] V S R 1: Reference stall speed in a specific configuration. [7] V SW: Speed at which the stall warning will occur. [7] V TOSS
For example, a 1995 Beretta features a 1650 rpm stall converter as opposed to a 1999 Century converter with a stall of 2095 rpm. In the 4T60 family of transmissions, the combination of drive-chain sprocket ratios and the differential gear ratio together offer up to 12 different possible final drive ratios to allow the transmission family to ...
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
V S: Stall speed: the speed at which the airplane exhibits those qualities accepted as defining the stall. [26]: 8 V S0: The stall speed or minimum steady flight speed in landing configuration. [27] The zero-thrust stall speed at the most extended landing flap setting. [26]: 8 V S1: The stall speed or minimum steady flight speed obtained in a ...
This means the output shaft rotates at the same speed as the selected gear, thus determining the gear ratio of the transmission. [16] The dog clutch is a sliding selector mechanism that sits around the output shaft. It has teeth to fit into the splines on the shaft, forcing that shaft to rotate at the same speed as the gear hub. However, the ...
The Tremec TR-6060 six-speed manual transmission features six forward speeds and one reverse speed. It is derived from the Tremec T-56 6-speed manual transmission. As usual, the forward helical cut gears are synchronized. However, the reverse gear operates through a fully synchronized constant-mesh system.
In the 45RFE applications four gears are utilized. In the 545RFE four gears are used on the upshift and a new "gear", 2nd Prime, was used with a different (1.50:1 rather than 1.67:1) ratio to increase versatility when downshifting. Although, with some tuning, you can get the 545RFE to upshift into 2nd Prime. [2]