Ads
related to: cracked bushings on control arms
Search results
Results From The WOW.Com Content Network
The inboard (chassis) end of a control arm is attached by a single pivot, usually a rubber bushing. It can thus control the position of the outboard end in only a single degree of freedom, maintaining the radial distance from the inboard mount. Although not deliberately free to move, the single bushing does not control the arm from moving back ...
The compliance of the bushings, the body, and other parts modify the behaviour of the suspension. In general it is difficult to improve the kinematics of a suspension using the bushings, but one example where it does work is the toe control bush used in Twist-beam rear suspensions .
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing) on one end to the wheel carrier or axle, on the other to the chassis or unibody of the vehicle. Radius rods are ...
A bushing is a type of bearing that is used in the suspension system of a vehicle. It is typically used to connect moving parts such as control arms and sway bars to the frame of the vehicle, and also to isolate these parts from each other and from the frame.
The front of the H attaches to the body via rubber bushings, and the rear of the H carries each stub-axle assembly, on each side of the car. The cross beam of the H holds the two trailing arms together, and provides the roll stiffness of the suspension, by twisting as the two trailing arms move vertically, relative to each other.
This is the determining factor in designed bump steer. Another factor that affects bump steer is bushing compliance and deflection and arm bending. During a turn, if some or all of the bushings deflect then their pickup points have changed If any of the arms and tie rods bend then their effective length will change resulting in a change of toe.