Search results
Results From The WOW.Com Content Network
The ipconfig command supports the command-line switch /all. This results in more detailed information than ipconfig alone. An important additional feature of ipconfig is to force refreshing of the DHCP IP address of the host computer to request a different IP address. This is done using two commands in sequence.
On a PC running Windows 10: On the task bar, select WiFi or Ethernet > click on the network you’re currently connected to > select Properties > your IP address is listed next to “IPv4 address.”
On some systems, the protocol name may be followed by "4" or "6", depending on whether the protocol is running over IPv4 or IPv6. Local Address – The IP address of the local computer and the port number being used. The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is ...
netsh, among many other things, also allows the user to change the IP address on their machine. Starting from Windows Vista, one can also edit wireless settings (for example, SSID) using netsh. netsh can also be used to read information from the IPv6 stack.
The FIND command is a filter to find lines in the input data stream that contain or don't contain a specified string and send these to the output data stream. It may also be used as a pipe . The command is available in MS-DOS versions 2 and later.
The command removes and corrects preloaded entries using a number of case-sensitive switches. The nbtstat -a < name > command performs a NetBIOS adapter status command on the computer name specified by < name >. The adapter status command returns the local NetBIOS name table for that computer as well as the MAC address of the
A public IP address is a globally routable unicast IP address, meaning that the address is not an address reserved for use in private networks, such as those reserved by RFC 1918, or the various IPv6 address formats of local scope or site-local scope, for example for link-local addressing. Public IP addresses may be used for communication ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router