Ad
related to: how to terminate rg6 cable router connection
Search results
Results From The WOW.Com Content Network
An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets.
A terminating resistor for a television coaxial cable is often in the form of a cap, threaded to screw onto an F connector. Antenna cables are sometimes used for internet connections; however, RG-6 should not be used for 10BASE2 (which should use RG-58) as the impedance mismatch can cause phasing problems with the baseband signal.
A given headend may have between 1–12 CMTSs to service the cable modem population served by that headend or HFC hub. One way to think of a CMTS is to imagine a router with Ethernet interfaces (connections) on one side and coaxial cable RF interfaces on the other side. The Ethernet side is known as the Network Side Interface or NSI.
The antenna is often mounted outdoors on the roof or a tower. A coaxial or twin-lead cable is run from the antenna to the location where the television is located. One common type of cable is designated RG-6 Tri-shield or quad-shield cable. The cable is terminated on a television outlets, typically an F connector mounted on a face plate. If ...
The BNC connector is a miniature quick connect/disconnect radio frequency connector used for coaxial cable. It is designed to maintain the same characteristic impedance of the cable, with 50 ohm and 75 ohm types being made. It is usually applied for video and radio frequency connections up to about 2 GHz and up to 500 volts.
The number was assigned sequentially. The RG unit indicator is no longer part of the JETDS system (MIL-STD-196E) and cable sold today under the RG-6 label is unlikely to meet military specifications. In practice, the term RG-6 is generally used to refer to coaxial cables with an 18 AWG (1.024 mm) center conductor and 75 ohm characteristic ...
The MDF is a termination point within the local telephone exchange where exchange equipment and terminations of local loops are connected by jumper wires at the MDF. All cable copper pairs supplying services through user telephone lines are terminated at the MDF and distributed through the MDF to equipment within the local exchange e.g. repeaters and DSLAM.
In order to terminate a Fiber Optic cable, the appropriate connector must be determined. The type of fiber-optic adapter that the terminated cable will connect to will dictate which connector will be used. The most common types that are added to fiber optic cable in inside plant environments are LC, SC, ST, and FC.