Search results
Results From The WOW.Com Content Network
Cable modem termination system. A cable modem termination system (CMTS, also called a CMTS Edge Router) [1] is a piece of equipment, typically located in a cable company's headend or hubsite, which is used to provide data services, such as cable Internet or Voice over IP, to cable subscribers.
A rollover cable (also known as a Yost cable, Cisco cable, or a console cable) is a type of null-modem cable that is used to connect a computer terminal to a router's console port. This cable is typically flat (and has a light blue color) to help distinguish it from other types of network cabling.
The antenna is often mounted outdoors on the roof or a tower. A coaxial or twin-lead cable is run from the antenna to the location where the television is located. One common type of cable is designated RG-6 Tri-shield or quad-shield cable. The cable is terminated on a television outlets, typically an F connector mounted on a face plate. If ...
The number was assigned sequentially. The RG unit indicator is no longer part of the JETDS system (MIL-STD-196E) and cable sold today under the RG-6 label is unlikely to meet military specifications. In practice, the term RG-6 is generally used to refer to coaxial cables with an 18 AWG (1.024 mm) center conductor and 75 ohm characteristic ...
A terminating resistor for a television coaxial cable is often in the form of a cap, threaded to screw onto an F connector. Antenna cables are sometimes used for internet connections; however, RG-6 should not be used for 10BASE2 (which should use RG-58) as the impedance mismatch can cause phasing problems with the baseband signal.
Wireless router [2] An internet box integrating a SIM Card. A modem (e.g. DSL modem, cable modem) by itself provides none of the functions of a router. [3] It merely allows ATM or PPP or PPPoE traffic to be transmitted across telephone lines, cable wires, optical fibers, wireless radio frequencies, or other physical layers. [4]
Two simple NIDs, carrying six lines each, on the outside of a building A German copper phone line termination box called Abschlusspunkt LinienTechnik (APL, "Demarcation point") In telecommunications , a network interface device ( NID ; also known by several other names) is a device that serves as the demarcation point between the carrier's ...
A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.