Ads
related to: bolt hitch pin lock keyed to vehicle key
Search results
Results From The WOW.Com Content Network
In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin In a pin tumbler lock, the key pin is in contact with the key. It has varying lengths, corresponding to the key's ...
Locks are usually re keyed to build master-key systems, make a set of locks share a common key, or to eliminate compromised keys. [2] [3] [4] Sometimes worn pins are replaced with new pins if the old pins become too short to reach the shear-line. [5] The shear-line is the thin line shared by the lock plug and its cylindrical housing. If a pin ...
In a master-keyed lock, some or all of the pin chambers in the lock have three pins in them instead of two. Between the driver pin and the key pin is a third pin called the spacer pin, also known as a master wafer. Thus each pin line has two shear points, one where the driver and spacer pins meet, and one where the spacer and key pins meet. So ...
Dealers will replace affected hitch receiver locks free of charge. The recalled mechanisms will be replaced with a single-piece design instead of the two-piece pin that caused the issue.
The bitting code is used in conjunction with a key's Depth and Spacing Number to completely determine all relevant information regarding the key's geometry. [1] Each number in the bitting code corresponds to a cut on the key blade. For example, a bitting code of 11111 with Depth and Spacing Number 46 specifies a Kwikset key with five shallow cuts.
Higher security lever locks (such as the five-lever) usually have notches cut into the levers. These catch the locking bolt and prevent it from moving if picking is attempted (similar to the security pins in a pin tumbler lock). The Chubb detector lock is a variation of the lever lock which was designed to detect and prevent picking attempts.