Ads
related to: proper nailer for attaching trim to concrete porch
Search results
Results From The WOW.Com Content Network
They can more easily be used in narrow or awkward locations, such as installing steel suspension clips into an overhead concrete ceiling. Powder-actuated tools are powered by small explosive cartridges, which are triggered when a firing pin strikes a primer, a sensitive explosive charge in the base of the cartridge.
A nail gun, nailgun or nailer is a form of hammer used to drive nails into wood or other materials. It is usually driven by compressed air ( pneumatic ), electromagnetism , highly flammable gases such as butane or propane , or, for powder-actuated tools , a small explosive charge .
Soil nails were used to stabilize an 18 metres (59 ft) high slope consisting of sandy soil. This method proved to be more cost-effective, while at the same time cut down the construction time when compared to other conventional support methods. [4]: 23 Germany was the next country to investigate soil nailing.
Nails are made in a great variety of forms for specialized purposes. The most common is a wire nail. [2] Other types of nails include pins, tacks, brads, spikes, and cleats. Nails are typically driven into the workpiece by a hammer or nail gun. A nail holds materials together by friction in the axial direction and shear strength laterally.
Our master carpenter gives us a tip on hiding nails when shingling, while our general contractor builds a cedar and fir deck for the new back entry. Out on the front porch, our master carpenter begins replacing the old, "wrong" square columns with new round ones, choosing between polymer/fiberglass/marble columns and traditional wood ones.
The American Concrete Institute (ACI, formerly National Association of Cement Users or NACU) is a non-profit technical society and standards developing organization. ACI was founded in January 1905 during a convention in Indianapolis.
German masons repointing a wall in 1948. Repointing is the process of renewing the pointing, which is the external part of mortar joints, in masonry construction. Over time, weathering and decay cause voids in the joints between masonry units, usually in bricks, allowing the undesirable entrance of water.
Engraving punch. A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other.