When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Grease fitting - Wikipedia

   en.wikipedia.org/wiki/Grease_fitting

   The grease gun hose is usually at a sharp angle (e.g. 70-90°) to the axis of the nipple but can be approached from any azimuthal angle. It is not possible for grease pressure to force this type of connector away from the nipple. Grease fittings are commonly made from zinc-plated steel, stainless steel, or brass.

3. Constant-velocity joint - Wikipedia

   en.wikipedia.org/wiki/Constant-velocity_joint

   A Rzeppa-type CV joint. A constant-velocity joint (also called a CV joint and homokinetic joint) is a mechanical coupling which allows the shafts to rotate freely (without an appreciable increase in friction or backlash) and compensates for the angle between the two shafts, within a certain range, to maintain the same velocity.

4. Universal joint - Wikipedia

   en.wikipedia.org/wiki/Universal_joint

   and it is seen that the output drive is just 90 degrees out of phase with the input shaft, yielding a constant-velocity drive. NOTE: The reference for measuring angles of input and output shafts of universal joint are mutually perpendicular axes. So, in absolute sense the forks of the intermediate shaft are parallel to each other.

5. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

6. Four-bar linkage - Wikipedia

   en.wikipedia.org/wiki/Four-bar_linkage

   The last link is the floating link, which is also called a coupler or connecting rod because it connects an input to the output. Assuming the frame is horizontal there are four possibilities for the input and output links: [2] A crank: can rotate a full 360 degrees; A rocker: can rotate through a limited range of angles which does not include 0 ...

7. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   Flared connections offer a high degree of long-term reliability and for this reason are often used in mission-critical and inaccessible locations. The tool used to flare tubing consists of a die that grips the tube, and either a mandrel or rolling cone is forced into the end of the tube to form the flare by cold working.