Ads
related to: markertek belden 8770 cable specs guide
Search results
Results From The WOW.Com Content Network
A category 3 cable. Cat 3 was widely used in computer networking in the early 1990s for 10BASE-T Ethernet and, to a much lesser extent, for 100BaseVG Ethernet, Token Ring and 100BASE-T4. The original Power over Ethernet 802.3af specification supports the use of Cat 3 cable, but the later 802.3at Type 2 high-power variation does not. [8]
It was acquired by Crouse-Hinds Company in 1980; Crouse-Hinds was acquired by Cooper Industries in 1981 and spun off Belden as an independent company in 1993. In 2004 the company merged with Cable Design Technologies forming Belden CDT Inc. (now Belden Inc.) and since then the company has been headquartered in St. Louis. In 2005 John Stroup ...
The physical-layer specifications of the Ethernet family of computer network standards are published by the Institute of Electrical and Electronics Engineers (IEEE), which defines the electrical or optical properties and the transfer speed of the physical connection between a device and the network or between network devices.
Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin Component. In popular use, it refers to a type of analog video information that is transmitted or stored as three separate signals. Either RGB interfaces or YPbPr: 3 RCA jacks: Composite, S-Video, and Component: VIVO = Mini-DIN 9-pin with breakout cable.
10BASE5 vampire tap Medium Attachment Unit (transceiver) 10BASE5 transceivers, cables, and tapping tool. 10BASE5 (also known as thick Ethernet or thicknet) was the first commercially available variant of Ethernet. The technology was standardized in 1982 [1] as IEEE 802.3. 10BASE5 uses a thick and stiff coaxial cable [2] up to 500 meters (1,600 ...
International standard ISO/IEC 11801 Information technology — Generic cabling for customer premises specifies general-purpose telecommunication cabling systems (structured cabling) that are suitable for a wide range of applications (analog and ISDN telephony, various data communication standards, building control systems, factory automation).
The interface specifications for the TNC and many other connectors are referenced in MIL-STD-348. [1] The connector has a 50 Ω impedance and operates best in the 0–11 GHz frequency spectrum. It has better performance than the BNC connector at microwave frequencies.
Cutaway diagram of a shielded multicore cable with four cores each with three individual conductors. A multicore cable is a type of electrical cable that combines multiple signals or power feeds into a single jacketed cable. [1] The term is normally only used in relation to a cable that has more cores than commonly encountered. [2]