Ads
related to: connector ecu engine
Search results
Results From The WOW.Com Content Network
A Rover V8 3.9L engine fitted with the 14CUX system. The engine control unit (ECU) of the 14CUX system is run by a Motorola MC6803U4 8-bit microprocessor, which is an uncommon variant of the otherwise ubiquitous 6803. The processor is mislabelled in the ECU, possibly to deter any reverse engineering efforts. The 14CUX determines fueling values ...
Delco ECU used in General Motors vehicles built in 1996. An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.
The Ford EEC or Electronic Engine Control is a series of ECU (or Engine Control Unit) that was designed and built by Ford Motor Company. The first system, EEC I, used processors and components developed by Toshiba in 1973. It began production in 1974, and went into mass production in 1975. It subsequently went through several model iterations.
OBD-II provides access to data from the engine control unit (ECU) and offers a valuable source of information when troubleshooting problems inside a vehicle. The SAE J1979 standard defines a method for requesting various diagnostic data and a list of standard parameters that might be available from the ECU.
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
The DDEC III ECM is thinner than the DDEC II ECM, with wiring connectors at both ends. The front-end has two five-pin connectors for the injectors, and a thirty-pin connector for the engine-sensors. The rear-end has a five-pin Power Connector, six-pin Communications Connector, and a thirty-pin Vehicle-Interface Harness-Connector.
The main connector is a 36-pin TE Connectivity 344108 ("Econoseal"), and its mating connector (used in the wiring harness) is a TE Connectivity 344111. On earlier versions of the system, a MAP sensor was internal to the ECU, requiring that an inlet manifold vacuum line be run to the ECU enclosure.
SAE J1939 has been adopted widely by diesel engine manufacturers. One driving force behind this is the increasing adoption of the engine Electronic Control Unit (ECU), which provides one method of controlling exhaust gas emissions within US and European standards.