Ads
related to: delta loop antenna wiring diagram plug with switch 3
Search results
Results From The WOW.Com Content Network
High-leg delta (also known as wild-leg, stinger leg, bastard leg, high-leg, orange-leg, red-leg, dog-leg delta) is a type of electrical service connection for three-phase electric power installations. It is used when both single and three-phase power is desired to be supplied from a three phase transformer (or transformer bank).
A ferrite loopstick antenna, a small loop used for AM reception in a portable radio, consisting of a wire wound around a ferrite core; the most common type of loop antenna today. A loop antenna is a radio antenna consisting of a loop or coil of wire, tubing, or other electrical conductor , that for transmitting is usually fed by a balanced ...
The common colors are black, red, blue, brown, yellow, and orange (high-leg delta) insulated wire, sometimes other colors. Specific exceptions apply, such as a cable running to a switch and back (known as a traveler) where the white wire will be the hot wire feeding that switch.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
[3] [12] [2] There are essentially two broad categories of loop antennas: large loops (or full-wave loops) and small loops. The halo is the only loop antenna does not exclusively fit in either the large loop or small loop category.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
A sense antenna normally consists of a single vertical antenna positioned some distance from the crossed loops, in line with one of the two loops, at a distance about the same as the distance between the two vertical portions of the loop. The sense antenna's output is mixed with the loop it is in-line with, through a switch that allows it to be ...