Ads
related to: overhand loop knot pattern instructions for knitting
Search results
Results From The WOW.Com Content Network
The overhand loop is a simple knot which forms a fixed loop in a rope. Made by tying an overhand knot in the bight , it can be tied anywhere along a rope (does not need any working end ). The knot can be used for attaching clips, hooks, other rope, etc., but has the disadvantage that it is likely to jam tight when the rope has been pulled and ...
Zeppelin bend forming a loop: the four stages of the method starting with a "clover leaf" or flattened overhand knot; Red line: ends of the overhand knot, Green line: ends of the underhand. Another method of remembering this knot is to visualize a "69". To tie the knot with this method, follow the steps below: Make a "6" with one line (rope) end.
The overhand knot is one of the most fundamental knots, and it forms the basis of many others, including the simple noose, overhand loop, angler's loop, reef knot, fisherman's knot, half hitch, and water knot. The overhand knot is a stopper, especially when used alone, and hence it is very secure, to the point of jamming badly. It should be ...
The yarn is formed into the desired number of loops with the desired length. These loop(s) are held behind the work, drawn through the desired stitch using the right-hand needle and placed on the left-hand needle next to the desired stitch. The loops and the desired stitch are knit together to secure the loops.
This version is tied using the clover method, starting with an overhand knot, then letting the working end pass in the following order through; first the eye of the clover (overhand knot) on the main part side along with the main part (thus forming the loop) then the loop itself opposite the direction of the main part
Below is a basic method of tying. The knot can also be made by using the rod itself to form the loop, but the tying method does not affect the performance of the resulting hitch. Begin with an overhand loop, that is, a loop in which the working part passes over the standing part:
Form an overhand noose, or simply tie an overhand knot around the standing part as shown. Tighten the overhand portion of the knot around the standing part. Thread the working part through the loop. First close the noose on the working part by pulling on the standing part, then remove any remaining slack in the knot by pulling on the working part.
A slipped half hitch [1] [2] is a knot in which the weight of the load the rope carries depresses the loop sufficiently to keep it in place until the load item is placed in its location. When no longer required the free end may be pulled and draw the loop through and so release the load.