Ad
related to: hacks for hiding computer wires and connectors free patterns templates images
Search results
Results From The WOW.Com Content Network
These wires are called wire bridges or jumpers, but unlike jumpers used for configuration settings, they are intended to permanently connect the points in question. They are used to solve layout issues of the printed wiring, providing connections that would otherwise require awkward (or in some cases, impossible) routing of the conductive traces.
Cable lacing is a method for tying wiring harnesses and cable looms, traditionally used in telecommunication, naval, and aerospace applications. This old cable management technique, taught to generations of lineworkers , [ 1 ] is still used in some modern applications since it does not create obstructions along the length of the cable, avoiding ...
Starting with the first binder group in the center, the technician counts the cable's groups in a spiral direction depending on the location of the central office or switch. If looking at the cable's core and the switch is in that direction, the groups are counted counter-clockwise. If the cable is the field side, the count is clockwise. There ...
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).
Wire wrapped backplane of an IBM 1401 computer, introduced in 1959 A modern wire wrap in a CFL. Manually wrapped wires were common in early 20th century point-to-point electronic construction methods in which a strong connection was needed to hold the components in place. Wires were wrapped by hand around binding posts or spade lugs and then ...
A tool called a punch down tool is used to push the wire down firmly and properly into the slot. Some will automatically cut any excess wire off. [ 1 ] The exact size and shape of the tool blade varies by manufacturer, which can cause problems for those working on existing installations, especially when there is a poorly documented mix of ...
Jump wire material for ready-made or homemade wires should usually be 22 AWG (0.33 mm 2) solid copper, tin-plated wire - assuming no tiny plugs are to be attached to the wire ends. The wire ends should be stripped 3 ⁄ 16 to 5 ⁄ 16 in (4.8 to 7.9 mm). Shorter stripped wires might result in bad contact with the board's spring clips ...
Color-coded PS/2 connection ports (purple for keyboards and green for mice) on the rear of a personal computer An S-video connector: because this is a female connector, Pin 1 is at lower right. Mini-DIN connectors are 9.5 millimetres (3 ⁄ 8 in) in diameter and come in seven patterns, with the number of pins from three to nine. Each pattern is ...