Search results
Results From The WOW.Com Content Network
The transmission line calculator can be used to design and analyze different types of transmission lines (e.g. microstrips, coaxial cables). A component library manager gives access to models for real life devices (e.g. transistors, diodes, bridges, opamps). These are usually implemented as macros. The library can be extended by the user.
The main disadvantage is the high current stress on the switch. [4] Fig. 1: Cuk converter circuit diagram. The capacitor C 1 is used to transfer energy. It is connected alternately to the input and to the output of the converter via the commutation of the transistor and the diode (see figures 2 and 3).
A typical use of these transistors is as a switch for moderate voltages and currents, including as drivers for small lamps, motors, and relays. [1] In switching circuits, these FETs can be used much like bipolar junction transistors, but have some advantages: high input impedance of the insulated gate means almost no gate current is required
The bipolar junction transistor, the first type of transistor to be mass-produced, is a combination of two junction diodes and is formed of either a thin layer of p-type semiconductor sandwiched between two n-type semiconductors (an n–p–n transistor), or a thin layer of n-type semiconductor sandwiched between two p-type semiconductors (a p ...
The pull-down resistor R 1 biases the transistor to the appropriate on-off threshold. The output is inverted since the collector-emitter voltage of transistor Q 1 is taken as output, and is high when the inputs are low. Thus, the analog resistive network and the analog transistor stage perform the logic function NOR. [3]
Learn how to download and install or uninstall the Desktop Gold software and if your computer meets the system requirements.
If your symptoms persist for more than 10 days If you experience difficulty breathing, develop a severe cough, notice thick green or yellow mucus, run a fever, and/or feel extremely fatigued
The collapsing flux induces primary current to flow out of the primary toward the now-open switch i.e. to flow in the same direction it was flowing when the switch was closed. For current to flow out of the switch-end of the primary, the primary voltage at the switch end must be positive relative to its other end that is at the supply voltage V b.