Search results
Results From The WOW.Com Content Network
However, the function of traffic shaping is more likely done by a Cable Modem or policy traffic switch. A CMTS may also act as a bridge or router. A customer's cable modem cannot communicate directly with other modems on the line. In general, cable modem traffic is routed to other cable modems or to the Internet through a series of CMTSs and ...
It can allow a direct connection from a home LAN to a WWAN, if a wireless router or access point is present on the WAN as well and tethering is allowed. Many modems now incorporate the features mentioned below and thus are appropriately described as residential gateways, such as some Internet providers which offer a cable modem router combo. [8]
The F connector (also F-type connector) is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or with RG-59/U cable.
The number was assigned sequentially. The RG unit indicator is no longer part of the JETDS system (MIL-STD-196E) and cable sold today under the RG-6 label is unlikely to meet military specifications. In practice, the term RG-6 is generally used to refer to coaxial cables with an 18 AWG (1.024 mm) center conductor and 75 ohm characteristic ...
Hulu + Live TV: Our top all-around pick. YouTube TV: Our pick for sports fans. Sling: Our pick for customization. Philo: Our pick for cheapest streaming. DirecTV Stream: Our pick for a cable-like ...
"Cable router" has two basic meanings: Single Cable Router (SCR) - a down-conversion device for the radio data link. It converts RF signal from a satellite dish or TV antenna to the user-defined IF channel. Usually, many SCRs are connected to a single coaxial cable - each converting to a separate IF channel. The entire system referred to as ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs). Crossover cables are sometimes still used ...