Ads
related to: chrysler tire pressure sensor reset
Search results
Results From The WOW.Com Content Network
A tire-pressure monitoring system (TPMS) monitors the air pressure inside the pneumatic tires on vehicles. [1] A TPMS reports real-time tire-pressure information to the driver, using either a gauge, a pictogram display, or a simple low-pressure warning light. TPMS can be divided into two different types – direct (dTPMS) and indirect (iTPMS).
direct TPM sensor fitted in valve system, manufacturer VDO. In most current designs of direct TPMS, a small electronic assembly which is rugged enough to be mounted inside a tire, measures the pressure using a microelectromechanical system (MEMS) [1] pressure sensor and then transmits this and other information to one or more vehicle receivers. [1]
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
For instance, on the Corvette there are interfaces for the Class 2 serial data stream from the PCM, the CCM diagnostic terminal, the radio data stream, the airbag system, the selective ride control system, the low tire pressure warning system, and the passive keyless entry system. [21] An OBD 1.5 has also been used in the Ford Scorpio since 95 ...
[citation needed] Volvo had a light labeled "lambda", lambda sond being another name for oxygen sensor. This was done in order to remind the driver to change the oxygen sensor. Some American-built 1973–1976 Chrysler Corporation vehicles had a similar odometer-triggered reminder: "Check EGR", which was reset after service at a Chrysler dealership.
The most important sensors are as follows: A steering wheel angle sensor that determines where the driver wants to steer. This kind of sensor often uses AMR elements. A yaw rate sensor that measures the rotation rate of the car. The data from the yaw sensor is compared with the data from the steering wheel angle sensor to determine regulating ...
In 2000, the tire-pressure monitoring system (TPMS) became available as an option. In January 2002, the STS received a new MagneRide adaptive suspension system, unavailable on the SLS, becoming the first production vehicle equipped standard with such suspension technology.
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...