Ads
related to: rosemount 400vp 11 pin switch
Search results
Results From The WOW.Com Content Network
A PIN diode switch can switch much more quickly (e.g., 1 microsecond), although at lower RF frequencies it isn't reasonable to expect switching times in the same order of magnitude as the RF period. For example, the capacitance of an "off"-state discrete PIN diode might be 1 pF. At 320 MHz, the capacitive reactance of 1 pF is 497 ohms:
hazard lights switch 85c hazard sound on Switches 81 opener 81a 1 out 81b 2 out 82 lock in 82a 1st out 82b 2nd out 82z 1st in 82y 2nd in 83 multi position switch, in 83a out position 1 83b out position 2 Relay; 85 relay coil - Important if relay coil has flyback diode in parallel 86 relay coil + Important if relay coil has diode in parallel
Keying by omitting a pin is also used in 8- (subminiature), 10-, and 12-pin tubes (a variant 10-pin form, "Noval+1", is basically a nine-pin socket with an added center contact). As with loctal tubes, the pins of miniature tube are stiff wires protruding through the bottom of the glass envelope which plug directly into the socket.
There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in). The 1.57 mm pin can carry 5 A of current, while the 2.36 mm can carry 8.5 A. Because the pins have a large contact surface area and fit tightly, these connectors are typically used for power.
ICs using bipolar junction transistors have V CC (+, positive) and V EE (-, negative) power-supply pins – though V CC is also often used for CMOS devices as well. [2]: 71
Five-pin male 180° DIN connector from a 1988 Schneider MF2 keyboard by Cherry. The DIN connector is an electrical signal connector that was standardized by the Deutsches Institut für Normung (DIN), the German Institute for Standards, in the mid 1950s, initially with 3 pins for mono, but when stereo connections and gear appeared in late 1950s (1959 or so), versions with 5 pins or more were ...
The former Soviet Union and Eastern bloc countries used similar packages, but with a metric pin-to-pin spacing of 2.5 mm rather than 0.1 inches (2.54 mm). The number of leads is always even. For 0.3 inch spacing, typical lead counts are 8, 14, 16, and 20; less common are 4, 6, 18, 24, and 28 lead counts.
The term may refer to each individual switch, or to the unit as a whole. This type of switch is designed to be used on a printed circuit board along with other electronic components and is commonly used to customize the behavior of an electronic device for specific situations. DIP switches are an alternative to jumper blocks. Their main ...