Search results
Results From The WOW.Com Content Network
A governor, or speed limiter or controller, is a device used to measure and regulate the speed of a machine, such as an engine.. A classic example is the centrifugal governor, also known as the Watt or fly-ball governor on a reciprocating steam engine, which uses the effect of inertial force on rotating weights driven by the machine output shaft to regulate its speed by altering the input flow ...
The drive shaft whose speed is being sensed is top right Porter governor on a Corliss steam engine. The devices shown are on steam engines. Power is supplied to the governor from the engine's output shaft by a belt or chain connected to the lower belt wheel. The governor is connected to a throttle valve that regulates the flow of working fluid ...
Pages in category "Steam engine governors" ... Watt governor This page was last edited on 15 September 2015, at 13:47 (UTC). Text is available under the Creative ...
Stuart Turner Ltd was incorporated in 1906 [2] and started to produce model steam engines, gas engines for domestic electricity, lathes, etc. Stuart Turner went on to produce further model steam designs, and in 1906 there were nine models in the range. By 1907 more space was needed so premises were rented at Market Place in the centre of Henley ...
1849 (): George Henry Corliss develops and markets the Corliss-type steam engine, a four-valve counterflow engine with separate steam admission and exhaust valves. Trip valve mechanisms provide sharp cutoff of steam during admission stroke. The governor is used to control the cut off instead of the throttle valve.
An oscillating cylinder engine cannot be reversed by means of the valve linkage (as in a normal fixed cylinder) because there is none. Reversing of the engine can be achieved by reversing the steam connections between inlet and exhaust or, in the case of small engines, by shifting the trunnion pivot point so that the port in the cylinder lines up with a different pair of ports in the port face.
A key requirement for the high-speed steam engine was accurate control of a constant speed, even under a rapidly changing load. Although the control of steam engines via a centrifugal governor dates back to Watt, this control was inadequate. These early governors operated a throttle valve to control the flow of steam to the engine. This gives ...
The variation of the steam consumption rate ṁ (kg/h) with the turbine load during throttle governing is linear and is given by the “willan’s line”. [1] The equation for the willan’s line is given by: ṁ=aL+C. Where a is the steam rate in kg/kWh, 'L' is the load on turbine in KW and C is no load steam consumption.