Ads
related to: displayport 5120x1440 cable size guideamazon.com has been visited by 1M+ users in the past month
sweetwater.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
The monitor only supported DisplayPort version 1.2, which is limited to 5120 × 2880 at 30 Hz. To work around this, the UP2715K implemented a system by which the bandwidth of two DisplayPort connections could be combined to achieve 60 Hz, using a picture-by-picture mode to virtually treat the display as two smaller 2560 × 2880 monitors side-by ...
DisplayPort version 1.3 added support for 5K at 60 Hz over a single cable, whereas version 1.2 was only capable of 5K at 30 Hz. Early 5K 60 Hz displays such as the Dell UltraSharp UP2715K and HP DreamColor Z27q that lacked DisplayPort 1.3 support required two DisplayPort 1.2 connections to operate at 60 Hz, in a tiled display mode similar to ...
Often now replaced by Mini DisplayPort. Female Micro-DVI port (rightmost) on MacBook Air: Micro-DVI: DVI-D dual link Replaced with Mini DisplayPort. DMS-59: twin DVI (for two monitors via an adapter cable) Apple Display Connector: Combines DVI, USB, and power. HDMI connector plugs (male): Type D (Micro), Type C (Mini), and Type A.
Four times the resolution of 1080p. Requires a dual-link DVI, category 2 (high-speed) HDMI, DisplayPort or a single Thunderbolt link, and a reduced scan rate (up to 30 Hz); a DisplayPort 1.2 connection can support this resolution at 60 Hz, or 30 Hz in stereoscopic 3D. 3840×2160 (8,294k) 3840 2160 8,294,400 16:9 24 bpp DCI 4K
The DisplayPort standard does not specify any maximum length for cables, though the DisplayPort 1.2 standard does set a minimum requirement that all cables up to 2 meters in length must support HBR2 speeds (21.6 Gbit/s), and all cables of any length must support RBR speeds (6.48 Gbit/s).
The data is transmitted via the cable connecting the display and the graphics card; VGA, DVI, DisplayPort and HDMI are supported. [ citation needed ] The EDID is often stored in the monitor in the firmware chip called serial EEPROM (electrically erasable programmable read-only memory) and is accessible via the I²C-bus at address 0x50 .