Search results
Results From The WOW.Com Content Network
AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.
A coiled garden hose. A garden hose, hosepipe, or simply hose is a flexible tube used to convey water. There are a number of common attachments available for the end of the hose, such as sprayers and sprinklers (which are used to concentrate water at one point or to spread it over a large area). Hoses are usually attached to a hose spigot or tap.
For example, a representative fraction of 1 ⁄ 1,000,000, often written as 1:1,000,000 or 1:1 mn, means that one inch (or one centimetre) on the map itself is equivalent to one million inches (or centimetres) in the real world. One statute mile is equal to 63,360 inches, so 1,000,000 inches is approximately 16 miles. [4] republic
A hose is a flexible hollow tube or pipe designed to carry fluids from one location to another, often from a faucet or hydrant. [ 1 ] Early hoses were made of leather, although modern hoses are typically made of rubber, canvas, and helically wound wire.
At its annual convention at Dallas, TX, the NFPA formally adopted a standard with 2 + 1 ⁄ 2-inch hose with 7.5 threads per inch as the primary standard, with additional sizes of 3 and 3.5 inches (each with 6 threads per inch) and a 4.5 inch coupling with 4 threads per inch, with the fire hydrant standard specifying one 4.5 inch port and two 2 ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Water is supplied at one end using a large hose. After sufficient irrigation has been applied to one strip of the field, the hose is removed, the water drained from the system, and the assembly rolled either by hand or with a purpose-built mechanism, so that the sprinklers are moved to a different position across the field. The hose is reconnected.
The "Air King" [14] universal air hose coupling, also known as a "Chicago style" fitting, is malleable iron or brass "quarter turn" "sexless coupling" usually found on large pneumatic tools like jackhammers. [6] The fitting is considered "universal", because a common two-lug head is used on all sizes ranging from 0.25 to 1 inch (6 to 25 mm).