Search results
Results From The WOW.Com Content Network
Minimum and maximum room ceiling heights, exit sizes and location; Qualification of individuals or corporations doing the work; For high structures, anti-collision markers for the benefit of aircraft; Building codes are generally separate from zoning ordinances, but exterior restrictions (such as setbacks) may fall into either category.
A curtain wall is an exterior covering of a building in which the outer walls are non-structural, instead serving to protect the interior of the building from the elements. Because the curtain wall façade carries no structural load beyond its own dead load weight, it can be made of lightweight materials.
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
A load-bearing wall or bearing wall is a wall that is an active structural element of a building — that is, it bears the weight of the elements above said wall, resting upon it by conducting its weight to a foundation structure. [1] The materials most often used to construct load-bearing walls in large buildings are concrete, block, or brick.
The UBC was first published in 1927 by the International Conference of Building Officials, which was based in Whittier, California.It was intended to promote public safety and provided standardized requirements for safe construction which would not vary from city to city as had previously been the case.
Historically, multiple approaches were suggested to address the reflection of the structure in the appearance of the architectural form. In the 19th-century Germany, Karl Friedrich Schinkel suggested that the structural elements shall remain visible in the forms to create a satisfying feeling of strength and security, [3] while Karl Bötticher as part of his "tectonics" suggested splitting the ...
An external wall insulation system (or EWIS) is a thermally insulated, protective, and decorative exterior cladding procedure involving the use of expanded polystyrene, mineral wool, polyurethane foam or phenolic foam, topped off with a reinforced cement based, mineral or synthetic finish and plaster. [2]
When the product is delivered to site the plasterer just needs to mix the product with water and apply it to the wall. The factory made render has an advantage over the site mixed render in that the composition of the render and all the raw materials are closely controlled and accurately measured. [ 8 ]