Ads
related to: best budget buffer tube for gas line removal from tank pump valve
Search results
Results From The WOW.Com Content Network
Mud Gas Separator is commonly called a gas-buster or poor boy degasser. It captures and separates the large volumes of free gas within the drilling fluid. If there is a "kick" situation, this vessel separates the mud and the gas by allowing it to flow over baffle plates. The gas then is forced to flow through a line, venting to a flare.
A DIN standard for gas cylinder valves for test pressures up to 300 bar (4,400 psi). EN 15202 [9] A European standard for LPG equipment and accessories, specifying LPG cylinder valve connections. [10] EN 417: European norm specification concerning non-refillable metallic cartridges for liquefied petroleum gases.
Most modern pumps have an automatic cut-off feature that stops the flow when the tank is full. This is done with an auxiliary sensing tube running from just inside the mouth of the nozzle to a Venturi pump in the pump handle. A mechanical valve in the pump handle detects a change of pressure and closes, preventing the flow of fuel. [28] [29]
Neck – A coaxial cylindrical extension of the shoulder with a threaded hole into which the cylinder valve or a gas pipe connection is fitted. [4] Boss – A sturdy insert, usually in the centre of the shoulder, into which a valve or gas pipe connection is fitted. [4] Base or foot – The end of the shell opposite the shoulder. [4]
The relief valve can be internal or external. The pump manufacturer normally has the option to supply internal relief or safety valves. The internal valve is usually used only as a safety precaution. An external relief valve in the discharge line, with a return line back to the suction line or supply tank, provides increased safety.
The gas supply was automatically cut-off by a spring loaded valve when the gas pressure reached the reserve pressure. To release the reserve, the diver pulled down on a rod that ran along the side of the cylinder and which activated a lever to open a bypass valve. The diver would then finish the dive before the reserve was consumed.
The initial section of the lower pipes provides for further gas/liquid separation and the far end provides a buffer storage volume for the liquids which are drawn off at a steady rate for further treatment. [3] The operating pressure in the slug catcher is maintained by a pressure controller and pressure control valve in the gas outlet.
For best results, the breech must be opened at the proper time, just as the forward momentum of the gases reaches its maximum, the peak flow. This means that bore extractors are normally used only on guns with semi-automatic or fully automatic actions, where the breech is opened and the shell ejected as part of the recoil process.