Search results
Results From The WOW.Com Content Network
Firearms use triggers to initiate the firing of a cartridge seated within the gun barrel chamber.This is accomplished by actuating a striking device through a combination of mainspring (which stores elastic energy), a trap mechanism that can hold the spring under tension, an intermediate mechanism to transmit the kinetic energy from the spring releasing, and a firing pin to eventually strike ...
[54] [55] [56] A trigger handle, which enabled the operator to fire the gun without affecting the stability of the gun's point of aim, was attached to the Tiefenfeuerautomat searchfire unit. On the Lafette 34 it could be adjusted for both semi-automatic firing and full-automatic firing mode, although some simplified late-war mounts had the ...
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
A forced reset trigger (or "hard reset" trigger) is a device that allows a person to fire a semi-automatic firearm at an increased rate. The forced reset trigger works by mechanically resetting the trigger's position after a shot is fired. This allows for an increased rate of fire.
A trigger disconnector captures the hammer in the cocked position after a shot has been fired, even if the trigger is held to the rear as the gun cycles. This ensures the gun can only fire in the semi-automatic mode, as the trigger needs to be released to 'reset' and have the disconnector release the hammer back to the trigger sear.
To qualify as a precision guided firearm, the system must: Be a complete firing system – rifle, ammunition and networked tracking scope; Persistently track the target, automatically compute a multi-variable firing solution, and ensure precise engagement when target and firing solution are optimally aligned
The MG 15 was developed from the MG 30, which was designed by Rheinmetall using the locking system invented by Louis Stange in the mid to late 1920s. Though it shares the MG 15 designation with the earlier gun built by Bergmann, the MG 15nA (for neuer Art, meaning new model having been modified from an earlier design) has nothing in common with the World War II gun except the model number.