Search results
Results From The WOW.Com Content Network
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...
long code "foot" outputs foot (and never feet) Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 ft (0.30 m) ftin (feet and inches) ft m (foot m) inch: in in Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 in (25 mm) in cm; in mm; Other: nautical mile: nmi nmi the international standard nautical mile
An image of N pixels height by M pixels wide can have any resolution less than N lines per picture height, or N TV lines. But when the pixel counts are referred to as "resolution", the convention is to describe the pixel resolution with the set of two positive integer numbers, where the first number is the number of pixel columns (width) and ...
Comparison of screen sizes by width, height, diagonal, ... typically measured in inches. ... 48 19 38 14.96 30 11.81 1136 447.24 48 19 39
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output. For example, if the output is "in hand", the inches value is rounded independently from the hands value.
They found that the underlying diameters of the stone circles had been consistently laid out using multiples of a base unit amounting to 30 long feet, which they calculated to be 1.056 of a modern international foot (thus 12.672 inches or 0.3219 m).
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM, together with the previously adopted conversion factor. [31]