Ads
related to: 300 ohm folded dipole tv antenna calculator manual instructionsget.usermanualsonline.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω , non-inductive. This allows the antenna impedance to swing from 400–1,600 Ω over the frequency range intended and thus keep the SWR at the transmitter 2:1 or lower.
German physicist Heinrich Hertz first demonstrated the existence of radio waves in 1887 using what we now know as a dipole antenna (with capacitative end-loading). On the other hand, Guglielmo Marconi empirically found that he could just ground the transmitter (or one side of a transmission line, if used) dispensing with one half of the antenna, thus realizing the vertical or monopole antenna.
For this reason, when attaching a twin-lead line to a coaxial cable connection, such as the 300 Ω twin-lead from a domestic television antenna to the television's 75 ohm coax antenna input, a balun with a 4:1 ratio is commonly used. Its purpose is double: First, it transforms twin-lead's 300 Ω impedance to match the 75 Ω coaxial cable ...
It is a two element Yagi-Uda antenna with folded dipole elements, and no director(s). Because of the folded ends, the element lengths are approximately 70% of the equivalent dipole length. The two-element design gives modest directivity (about 2.0 dB ) with a null towards the rear of the antenna, yielding a high front-to-back ratio : Gain up to ...
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
Generally the mutual coupling tends to lower the impedance of the primary radiator and thus, folded dipole antennas are frequently used because of their large radiation resistance, which is reduced to the typical 50 to 75 Ohm range by coupling with the passive elements. Two Yagi–Uda antennas on a single mast.
The 1 / 2 λ dipole and the 1 / 2 λ folded dipole are commonly taken as having nominal impedances of 75 Ω and 300 Ω, respectively. [13] An installed antenna's feed-point impedance varies above and below the quoted value, depending on its installation height above the ground and the electrical properties of the surrounding earth.
Indoor antennas are designed to be located on top of or next to the television set, but are ideally placed near a window in a room and as high up as possible for the best reception. [1] The most common types of indoor antennas are the dipole [2] ("rabbit ears"), which work best for VHF channels, and loop antennas, which work best for UHF. [3]