Search results
Results From The WOW.Com Content Network
The final drive ratios of the CJ-7 were different for each type of engine: the 145 cu in (2.4 L) diesel was mated to the 4.10 ratio axle (in both Renegade and Laredo), while the 258 cubic-inch straight six and 150 cubic-inch four-cylinder used 3.73 and AMC V8 304-powered models (produced 1976–1981, which became part of the Golden Eagle ...
Engine bay of a 1993 Jeep Grand Cherokee with 4.0 L The 5 millionth Jeep 4.0 engine produced on the "Greenlee Block Line" dated June 15, 2001 The 242 cu in (4.0 L) engine was developed by AMC in just 26 months using many off-the-shelf components while featuring, among others, additional strength, improved combustion chamber, port setup, and cam ...
Willys vehicles with this engine were designated 4-73 model. [6] This engine was unavailable in the CJ series until the introduction of the CJ-3B version in 1953, which had a distinctive high hood to accommodate the much taller engine. [2] Production of this engine continued through 1971, which was after American Motors Corporation (AMC ...
The engines in Jeeps featured a heavier flywheel than the Buick version to help dampen vibrations resulting from the engine's firing pattern. The engine was known at the time for its power and reliability. It would idle slowly, but not as smooth as other engines, especially the inline sixes. This engine was used in the following vehicles: Jeep CJ-5
The Jeep Tornado engine was the first post-World War II U.S.-designed mass-produced overhead cam (OHC) automobile engine. [1] The 230.5 cu in (3.78 L) hemi-headed straight-six was introduced in mid-year 1962, and replaced the flathead "6-226" Willys Super Hurricane that was in use since 1954.
Jeep CJ; Jeep Wagoneer/Grand Wagoneer; Kaiser Jeep was purchased by AMC in 1970. The Buick 350 cu in (5.7 L) V8, AMC 232 I6, and AMC 327, 360 V8 engines in the FSJ Wagoneer and trucks used a 'nailhead' pattern TH400—also known as a "unipattern," as it was used by many other manufacturers (including Rolls-Royce and Jaguar) with an adapter ring—from 1965 to 1972.
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
At that time, the only "small" engines generally offered by GM were built by the Chevrolet division including the 140 cu in (2.3 L) OHC aluminum inline-four engine used in the subcompact Chevrolet Vega and a 250 cu in (4.1 L) straight-6 used in smaller Chevy, Buick, Oldsmobile and Pontiac models, whose design roots dated back to the 1962 Chevy ...