When.com Web Search

  1. Ads

    related to: draining and flushing water heater necessary for a house to heat up air

Search results

  1. Results From The WOW.Com Content Network
  2. Here's How Often You Should Drain Your Water Heater ... - AOL

    www.aol.com/heres-often-drain-water-heater...

    Step 3: Attach a water hose to the drain valve at the bottom of your water heater and run the hose outside or into a nearby drain. You can use any generic hose for this step, and a garden hose ...

  3. Water heat recycling - Wikipedia

    en.wikipedia.org/wiki/Water_heat_recycling

    Installation of a double-walled copper-on-copper heat exchanger in a vertical section of the master drain line in a Canadian home (2007) Water heat recycling (also known as drain water heat recovery, waste water heat recovery, greywater heat recovery, [citation needed] or sometimes shower water heat recovery [citation needed]) is the use of a heat exchanger to recover energy and reuse heat ...

  4. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.

  5. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    In traditional plumbing in the UK, the space-heating boiler is set up to heat a separate hot water cylinder or water heater for potable hot water. Such water heaters are often fitted with an auxiliary electrical immersion heater for use if the boiler is out of action for a time. Heat from the space-heating boiler is transferred to the water ...

  6. Expansion tank - Wikipedia

    en.wikipedia.org/wiki/Expansion_tank

    An expansion tank or expansion vessel is a small tank used to protect closed water heating systems and domestic hot water systems from excessive pressure. The tank is partially filled with air, whose compressibility cushions shock caused by water hammer [citation needed] and absorbs excess water pressure caused by thermal expansion. [1]

  7. Air lock - Wikipedia

    en.wikipedia.org/wiki/Air_lock

    'S' trap inlet to drain [further explanation needed]. The air lock phenomenon can be used in a number of useful ways. An 'S' trap (a pipe that descends from a reservoir, then curves back up, then down again) allows liquid to flow from top to bottom unhindered, and gas cannot flow through the trap unless it has enough extra pressure to overcome the liquid head of the trap.

  1. Ad

    related to: draining and flushing water heater necessary for a house to heat up air