Ads
related to: 50 to one fuel mixture test chart calculator template
Search results
Results From The WOW.Com Content Network
Flammability diagrams show the control of flammability in mixtures of fuel, oxygen and an inert gas, typically nitrogen. Mixtures of the three gasses are usually depicted in a triangular diagram, known as a ternary plot. Such diagrams are available in the speciality literature.
Mixture fraction is a quantity used in combustion studies that measures the mass fraction of one stream of a mixture formed by two feed streams, one the fuel stream and the other the oxidizer stream. [ 1 ] [ 2 ] Both the feed streams are allowed to have inert gases. [ 3 ]
A breathing gas is a mixture of gaseous chemical elements and compounds used for respiration. The essential component for any breathing gas is a partial pressure of oxygen of between roughly 0.16 and 1.60 bar at the ambient pressure. The oxygen is usually the only metabolically active component unless the gas is an anaesthetic mixture.
Lower flammability limits for many organic materials are in the range of 10–50 g/m 3, which is much higher than the limits set for health reasons, as is the case for the LEL of many gases and vapours. Dust clouds of this concentration are hard to see through for more than a short distance, and normally only exist inside process equipment.
A different system for low-altitude boost known as MW 50 was also used, although GM-1 and MW 50 were rarely used on the same engine. MW-50 injected a methanol-water mixture into the cylinders to cool the mix. Cooling causes the air to become denser, therefore allowing more air into each cylinder for a given volume.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The advantage of using equivalence ratio over fuel–oxidizer ratio is that it takes into account (and is therefore independent of) both mass and molar values for the fuel and the oxidizer. Consider, for example, a mixture of one mole of ethane (C 2 H 6) and one mole of oxygen (O 2). The fuel–oxidizer ratio of this mixture based on the mass ...
Reaction stoichiometry describes the 2:1:2 ratio of hydrogen, oxygen, and water molecules in the above equation. The molar ratio allows for conversion between moles of one substance and moles of another. For example, in the reaction 2 CH 3 OH + 3 O 2 → 2 CO 2 + 4 H 2 O. the amount of water that will be produced by the combustion of 0.27 moles ...