When.com Web Search

  1. Ads

    related to: toilet fill valve leaking air

Search results

  1. Results From The WOW.Com Content Network
  2. Flush toilet - Wikipedia

    en.wikipedia.org/wiki/Flush_toilet

    The concentric-float fill valve is also designed to signal to users automatically when there is a leak in the tank, by making much more noise when a leak is present than the older style side-float fill valve, which tends to be nearly silent when a slow leak is present. Newer fill valves have a delayed action that will not start filling the tank ...

  3. Low-flow fixtures - Wikipedia

    en.wikipedia.org/wiki/Low-flow_fixtures

    Leaking fixtures can contribute to significant water waste. According to the EPAs WaterSense, a leaky faucet that drips at a rate of one drip per second can waste more than 3,000 gallons of water per year. [21] Old and worn out rubber valve seals in a toilet tank can lead to significant leaks causing the toilet to refill constantly. Some leaky ...

  4. Ballcock - Wikipedia

    en.wikipedia.org/wiki/Ballcock

    A later innovation, the floatless fill valve, designed for low-profile, low-flow toilet tanks, uses a pressure-sensing diaphragm mechanism instead of a float to control the inlet valve. [4] Delay valves, which delay the filling until the level has dropped to a low level, avert short-cycling of the water supply.

  5. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    Air admittance valves (AAVs, or commonly referred to in the UK as Durgo valves and in the US as Studor vents and Sure-Vent®) are negative-pressure-activated, one-way mechanical valves, used in a plumbing or drainage venting system to eliminate the need for conventional pipe venting and roof penetrations.

  6. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.

  7. Flushing trough - Wikipedia

    en.wikipedia.org/wiki/Flushing_trough

    As the water is siphoned from the trough, water is also sucked from the timing box and the water level inside the box falls rapidly, with air drawn into the timing box through a 'snorkel' vent pipe. When the timing box has been emptied of water, air flows through the timing box and into the siphon to break the siphonic action, stopping the flush.