Ads
related to: generator tool box combo ball bearing 1 375 od
Search results
Results From The WOW.Com Content Network
The flex spline fits tightly over the wave generator, so that when the wave generator plug is rotated, the flex spline deforms to the shape of a rotating ellipse and does not slip over the outer elliptical ring of the ball bearing. The ball bearing lets the flex spline rotate independently to the wave generator's shaft. The circular spline is a ...
A cannon bearing or cannon box bearing is an arrangement of bearings on a shaft, usually an axle, where two bearings are mounted in an enclosed tube. The function of the cannon box is to preserve the alignment of the two bearings, even if the overall tube is allowed to move. The two bearings will retain their same relative position.
The thrust box was built of a box-like cast iron housing with a radial bearing at each end and a number of collars formed on the shaft between them. [3] This shaft was often a short section of removable shaft called the thrust shaft, linking the engine ahead to the propeller shaft astern. A series of iron horseshoe-shaped collars fitted over ...
Working principle for a ball bearing; red dots show direction of rotation. A four-point angular-contact ball bearing. A ball bearing is a type of rolling-element bearing that uses balls to maintain the separation between the bearing races. The purpose of a ball bearing is to reduce rotational friction and support radial and axial loads. It ...
[1] Thrust bearings come in several varieties. Thrust ball bearings, composed of bearing balls supported in a ring, can be used in low-thrust applications where there is little axial load. Cylindrical roller thrust bearings consist of small cylindrical rollers arranged flat with their axes pointing to the axis of the bearing. They give very ...
The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.