Search results
Results From The WOW.Com Content Network
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
A rocker arm is a valvetrain component that typically transfers the motion of a pushrod in an overhead valve internal combustion engine to the corresponding intake/exhaust valve. Rocker arms in automobiles are typically made from stamped steel, or aluminum in higher-revving applications.
Moving rods or cables are attached to the outer ends of the L. When one is pulled, the L rotates around the pivot point, pulling on the other rod. A typical 180-degree bellcrank consists of a straight bar that pivots at or near its center. When one rod is pulled or pushed, the bar rotates around the pivot point, pulling or pushing on the other rod.
The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...
The opposite arrangement, a "pull rod", will pull on the rod during bump travel, and the rod must be attached to the top of the upright, angled downward. Locating the spring and damper inboard increases the total mass of the suspension, but reduces the unsprung mass, and also allows the designer to make the suspension more aerodynamic.
The rocker cover has been removed, so the pushrods, rocker arms, valve springs, and valves are visible. A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine . [ 1 ]
The MacPherson strut is a common form of strut suspension. This was not the first attempt at strut suspension, but in MacPherson's original patent, the anti-roll bar forms an integral and essential part of the suspension, in addition to its usual function in controlling body roll. A strut suspension like MacPherson's requires a hinged lower ...
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.