Search results
Results From The WOW.Com Content Network
The output for the front drive shaft is on the right side and the rear output is in line with the input. This enables 2-wheel High to be direct-drive, which is quieter. Otherwise the Dana 20 offers the same drive modes as the Dana 18. Its low range has a ratio of 2.03:1. The Dana 20 is generally compatible with the "big hole" Dana 18.
When in "4-Low" mode the front and rear axles are locked together and power is sent to all four-wheels through the power transfer unit although no low range gear reduction occurs. Active Drive low relies on shorter axle gear ratios while holding first gear in the ZF9HP transmission to achieve a crawl ratio of 20:1; similar in effect to Freedom ...
The line was offered in four ratings, M-300, M-375 (also known as M-400 between 1969–1973), [1] M-500, and M-600 depending on the application. The M600 was offered with the Rockwell F-130-NX rear axle, with a 4.88:1 gear ratio. By 1979, Chrysler Corporation no longer sold incomplete chassis and ended production of the M series.
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The Dana S110 is a full floating, drop-out axle. Dana S110 axles are a step up in overall strength compared to the Dana 80. Ford started using this axle in 2005 model F-450 and F-550 trucks. Replacing the Dana 80 in some class 4 trucks, and the Dana S 135 in the rest of the trucks. Dodge started using the Dana S110 in their 2008 model 4500 and ...
1964–1974 Chrysler A833 — 4-speed manual manufactured by New Process Gear [2] 1970–1981 Chrysler A230 — 3-speed manual, all-synchromesh; 1973–1974 Chrysler A250 — 3-speed manual, 1st gear no synchromesh [3] 1975–1978 Chrysler A390 — 3-speed manual, all-synchromesh [4] 1976–1980 Chrysler A833 — 4-speed manual overdrive (NPG) [5]
The transfer case may contain one or more sets of low range gears for off-road use. Low range gears are engaged with a shifter or electronic switch. In many transfer cases, this shifter is the same as the one that selects 2WD or 4WD operation. Low range gears allow the vehicle to drive at much slower speeds while still operating within the ...
Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.