Search results
Results From The WOW.Com Content Network
By using an NIC as a negative resistor, it is possible to let a real generator behave (almost) like an ideal generator, (i.e., the magnitude of the current or of the voltage generated does not depend on the load). Figure: Negative impedance converter. An example for a current source is shown in the figure on the right.
OC-48 is also used as a transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Slower cards that drop to OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 terminal would not allow for full use of the ...
The base value should only be a magnitude, while the per-unit value is a phasor. The phase angles of complex power, voltage, current, impedance, etc., are not affected by the conversion to per unit values. The purpose of using a per-unit system is to simplify conversion between different transformers.
Mode conversion occurs when a wave encounters an interface between materials of different impedances and the incident angle is not normal to the interface. [1] Thus, for example, if a longitudinal wave from a fluid (e.g., water or air) strikes a solid (e.g., steel plate), it is usually refracted and reflected as a function of the angle of incidence, but if some of the energy causes particle ...
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
What makes it promising: Hue is bringing the power of TikTok-style video reviews to brands and retailers, significantly increasing conversion rates and time spent on-site. Founded by a trio of ...
NDIS Miniport drivers can also use Windows Driver Model interfaces to control network hardware. [19] Another driver type is NDIS Intermediate Driver. Intermediate drivers sit in-between the MAC and IP layers and can control all traffic being accepted by the NIC. In practice, intermediate drivers implement both miniport and protocol interfaces.
Resolution of 1 ps with a 100 MHz (10 ns) clock requires a stretch ratio of 10,000 and implies a conversion time of 150 μs. [13] To decrease the conversion time, the interpolator circuit can be used twice in a residual interpolator technique. [13] The fast ramp is used initially as above to determine the time. The slow ramp is only at 1/100.