Search results
Results From The WOW.Com Content Network
A CMOS transistor NAND element. V dd denotes positive voltage.. In CMOS logic, if both of the A and B inputs are high, then both the NMOS transistors (bottom half of the diagram) will conduct, neither of the PMOS transistors (top half) will conduct, and a conductive path will be established between the output and Vss (ground), bringing the output low.
OR-AND-invert gates or OAI-gates are logic gates comprising OR gates followed by a NAND gate. ... One possibility of implementing an XOR gate is by using a 2-2-OAI ...
The NAND gate has the property of functional completeness, which it shares with the NOR gate. That is, any other logic function (AND, OR, etc.) can be implemented using only NAND gates. [2] An entire processor can be created using NAND gates alone. In TTL ICs using multiple-emitter transistors, it also requires fewer transistors than a NOR gate.
An AOI21 logic gate in CMOS using a complex gate (left) and standard gates (right) AND-OR-invert (AOI) and OAI gates can be readily implemented in CMOS circuitry. AOI gates are particularly advantaged in that the total number of transistors (or gates) is less than if the AND, NOT, and OR functions were implemented separately.
In principle any method that leads to a gate that is functionally complete (for example, either a NOR or a NAND gate) can be used to make any kind of digital logic circuit. Note that the use of 3-state logic for bus systems is not needed, and can be replaced by digital multiplexers, which can be built using only simple logic gates (such as NAND ...
Wired OR gate using open-collector NOR gates. With active low open collector logic outputs, as used for control signals in many circuits, an OR function can be produced by wiring together several outputs. This arrangement is called a wired OR. This implementation of an OR function typically is also found in integrated circuits of N or P-type ...
As an example, consider the static logic implementation of a CMOS NAND gate: This circuit implements the logic function = ¯ If A and B are both high, the output will be pulled low. If either A or B are low, the output will be pulled high. At all times, the output is pulled either low or high.
An XNOR gate can be implemented using a NAND gate and an OR-AND-Invert gate, as shown in the following picture. [3] This is based on the identity ¯ (¯) ¯ An alternative, which is useful when inverted inputs are also available (for example from a flip-flop), uses a 2-2 AND-OR-Invert gate, shown on below on the right.